Custom Made Gate Frame
ATTENTION: This option is available only for Melbourne based customers for pickup from Dandenong South or Delivery within 50KM’s AFTER COMPLETION (additional transport charges apply) .
If one of our ready made gates cannot suit your requirement then our cost effective custom gates allow for full flexibility to suit just about any installation. We offer both Raked and Level options allowing for you to nominate different heights on each side (see definition of sides below) OR run one universal height for the entire frame.
For custom fabrications all gates are constructed to above standard with 50x50mm Top, Sides and All internal Bracing and a 100x50mm bottom Rail, Then coated with your desired powder coat colour (Dulux powder coat).
How It Works
Raked vs. Normal Gates
“Normal” Gates
A “Normal” gate uses one universal height for both sides of the gate, this option is typically used for driveways which are level (or near to). For this option measure the height on both sides of the gate position (Start and end) and work on using the shorter of the measurements.
Raked Gates
A gate constructed on a rake means that one side is higher than the other, the gate is always constructed to be level on the top when installed but the bottom of the gate is on an angle. Measuring for a raked gate occurs from the the following perspective: The gate height (Left sand Right) Is always measured from the inside looking towards the street. The measurement occurs at the start and end of the gate position.
Colours
Powder Coating is standard just select the colour, we offer the option of near to every popular colorbond colour, if its not in the list just reach out and let us know.
Structure
All our custom gates are constructed of 50x50mm SHS Aluminium Tubing for the TOP, SIDES and SUPPORT STRUCTURE. The Bottom rail is constructed of RHS 100x50mm.
Hinge Options (Additional)
Automation
Take your pick in our best in class and over spec. Titan operators. Available in Electric, Low Voltage and Solar Powered, theres always a top end option to suit, Dont forget to fine tune your Orion LS kit in its Kit Contents Tab.
Orion LS Solar Powered Automatic Swing Driveway Gate Opener 24 Volt Kit Slimline Compact Design BASE KIT
$1,196.00
$1,166.00
Save $30.00
Example of Technical Drawing
Below is an example of the technical drawing you will be provided for approval after ordering.