WIRELESS Automatic Vehicle Detection Sensor – for Automatic Opening of gate and Presence Detection
An easy to install WIRELESS AUTOMATIC OPENING and PRESENCE driveway vehicle detection system
Multiple hours saved, materials saved and frustrations gone
Long gone are the days of cutting concrete, chasing wires and configuring induction loop detectors (ground loop). Finally, a simple WIRELESS solution to streamline the installation process.
The WIRELESS loop detector SIMPLY BOLT DOWN to a concrete driveway (or concrete pad in gravel driveways) and wirelessly communicate back with the gate system using the supplied high security (128 Bit) transceiver for two way communication between the New Generation wireless loops.
The wireless PRESENCE “loop” is maintenance free and installed with Replaceable Lithium batteries for up to TEN YEAR use period before a battery replacement is required, to replace the batteries simply remove the top cover and fit the new Lithium batteries.
* 10 year battery lifetime based on 50 activations per day, 8 years at 100 activations per days, 4 years at 300 activations per day.
How does it work and what happens if I accidently drive over it?
The wireless loop is designed for a vehicle to drive over and will detect the undercarriage of the vehicle. Typically the system is set to Automatic closing and the wireless loops radar technology will hold the open command till the vehicle is clear of the sensor. If its accidently driven over it presents no issue whatsoever as its casing carries a static load capacity of 10,000kg (10 Tonnes).
Note: Photocells must still always be installed as the typical safety device.
How far can i have it from the gate?
Thanks to its high transmission range capabilities it has a maximum wireless operating distance of 50 meters. However being also a presence detector it is typically installed at the gate to prevent the gate from closing til clear. (Exit sensor also available for automatic opening only).
How big is it?
Its compact form factor allows for a discreet installation measuring only 220x220mm Length and Width and only 26mm in height.
Will it work with my system?
Typically, YES, it will work with any gate system that has an OPEN command input and an accessories voltage output of 12-24V DC. The open command input of the system must hold the system OPEN when latched on.
Which installations does this suit?
Any domestic installations which fit the following criteria:
✓A concrete pad or driveway is available for the device to be installed on to
✓The device does not sit in a recess and pool water, snow or any debris
✓Not nearby to high voltage cables
How is it installed?
1. Connect the transceiver to the gates control board, this must be installed within the gate controller or any enclosure
2. Power on the transceiver and have the loop touching the antenna of the transceiver.
3. Once the transceiver flashes its blue led and the loop flashes its yellow led they are now paired together.
4. Remove backing plate from the loop and install to concrete using the supplied concrete screw bolts, ensure the arrow faces the direction of travel for exit (faces towards the gate).
5. Install the wireless loop to the backing plate and allow 3 minutes for calibration
Test to confirm operation, job done!
Supplied With
✓1x Commercial Wireless Loop (with Lithium Batteries Installed)
✓1x Transceiver
✓1x Allen Key
✓2x Concrete Screw Bolts